CMDS board

The new CMDS board has been designed with (1) 40 I/O chip to be connected to the digital I/O I2C channel of the PSCockpit system. It comes with corresponding elements (resistors, connectors, …) to work with 5V and two selectable mini-switches to select the desire I2C addresses. The board is prepared for 6 mm toggle switches but it has room to drill holes up to 12 mm diameter.

The following components are also inlcuded:
- (25) SMD leds for lettering backlight.
- (2) SMD leds for GO and NO GO indication.
- (3) SMD leds for DISPENSE READY indication
- (1) Rotary switch with 5 positions 45º
- (1) Rotary switch with 6 positions 30º
- Dimmer circuit for SLG2016 displays with a potentiometer of 10K. This pot comes apart so you can locate it in any other place of your pit.

You will find the following elements in the backside:
- (1) Connector for backlight illumination.
- (1) Connector for digital I/O I2C channel,
- (1) Miniswitch to select digital I2C channel address
- (1) Connector for7 free digital I/Os of the 40 I/O board.
- (1) Selectable connector for dimmer/CMDS_OFF bit

To complete the CMDS board, it can be supplied with the optional following elements:
- (8)Mini Toggle ON-OFF switches of 6 mm diameter. One of them comes with a locking lever for the JETT switch. Be aware that these switches are smaller than the real ones.
- SLG2016 displays, or
- HDGL-1414 displays, or
- 7 Segment display board with 8 digits of 4.22 x 7.62 mm

If you select the CMDS board with the switches and one of the displays options you will only have to add by yourself the CMDS case and the PRGM and MODE knobs for the rotary switches.

Please check the dimensions for the CMDS case at:
Link

Regards,
Shep